Automatic Gain Control Microphone

Automatic Gain Control Microphone

This project focused on developing a functional microphone system with automatic gain control to maintain consistent audio output in varying noise conditions. As a member of the mechanical engineering team, I designed the microphone housing and evaluated physical materials to improve acoustic perfor...
3D CAD modeling & design intentAcoustics-informed mechanical designMaterial selection & performance testingPrototype fabricationIterative design optimizationDesign for manufacturabilityTeam-based engineering collaboration
Reusable Imaging Chamber

Reusable Imaging Chamber

This ongoing undergraduate research project focuses on designing a reusable imaging chamber to replace the current single-use coverslip slide system used in microscopy. The existing setup relies on thin cover slides and silicone O-rings that are fragile, difficult to clean, and unstable on the micro...
Parametric CAD design & iterationConcept comparison and trade-off analysisMechanical sealing system designDesign for laboratory usabilityResearch-driven engineering developmentEarly-stage design for manufacturability

Ice Shield CAD Work (NX)

For my Engineering Communications and CAD course at Rensselaer Polytechnic Institute, I was tasked with the precision modeling of an "Ice Shield." The objective was to transform a high-detail 2D technical specification into a geometrically accurate 3D model, ensuring every fillet, radius, and sectio...
Software: Siemens NX / Autodesk Inventor (depending on which you used for this specific clip)Technical Drafting: GD&T (Geometric Dimensioning and Tolerancing) interpretation, Section Views, and Detail Scaling.Mechanical Design: 3D Part Modeling, Patterning, and Filleting.Quality Control: Dimension verification and document management.